2014 Nissan Armada TA60 Workshop Service Repair Manual
UNIT DISASSEMBLY AND ASSEMBLY
16. Thrust bearing lower 19. Pilot converter
22. Drive plate
25. Rear oil seal
28. Crankshaft position sensor (POS) 31. Connector cap (for Canada)
Disassembly and Assembly
DISASSEMBLY
NOTE:
17. 20. 23. 26. 29.
Main bearing lower Thrust bearing upper Reinforcement plate Transmission Gasket (for Canada)
18. 21. 24. 27. 30.
Crankshaft
Side bolt
Rear oil seal retainer
O-ring
Cylinder block heater (for Canada)
• Oil pan (upper and lower) and oil strainer. Refer to EM-35, “Removal and Installation”.
• Crankshaft pulley, front cover and timing chain. Refer to EM-57, “Removal and Installation”. K • Camshaft. Refer to EM-62, “Removal and Installation”.
2014 Nissan Armada TA60 Workshop Service Repair Manual
• Cylinder head. Refer to EM-78, “Removal and Installation”.
Explained here is how to disassemble with engine stand supporting transmission surface. When using differ- ent type of engine stand, some steps may be different.
1. Remove engine assembly and mount to engine stand. Refer to EM-88, “Removal and Installation”. CAUTION:
Before removing the hanging chains, make sure engine stand is stable and there is no risk of over- turning.
2. Drain engine oil. Refer to LU-9, “Changing Engine Oil”.
3. Drain engine coolant by removing the cylinder block drain plugs (A), (B), (C) and (D) as shown.
NOTE:
For cylinder block heater equipped engines, water drain plug (C) shown is not a water drain plug but a cylinder block heater.
4. Remove the following components and associated parts (the parts referred to in step 1 are not included here).
5. Remove knock sensor and sub harness.
CAUTION:
Carefully handle sensor, avoiding shocks.
